Legend Tuned · Chip Tuning
BMW 5 Series (G30/G31) M550d xDrive (B57) 400 HP Chip Tuning
- 2017–2023
- Diesel
- 400 HP · 760 Nm
- ECU: Bosch MD1
Target with Legend Tuned Stage 1: 460 HP / 880 Nm; with Stage 2: 490 HP / 925 Nm. The original software is backed up, the calibration is tailored to the car, and the result is verified by datalog.
Legend Tuned figures
Figures are examples/estimates and may vary with the car's mileage, maintenance condition, fuel quality and hardware. Exact results are determined by dyno/datalog.
Power & torque curve
Stock vs Stage comparison
A representative power and torque curve with a technical table of all figures. Hover over the chart to see values by rpm.
- Power · Stage 1
- Torque · Stage 1
- Power · Stock
- Torque · Stock
Technical figures
| Value | Stock | Stage 1 | Stage 2 |
|---|---|---|---|
| Power | 400 HP | 460 HP | 490 HP |
| Power (kW) | 294 kW | 338 kW | 360 kW |
| Torque | 760 Nm | 880 Nm | 925 Nm |
| Power gain | — | +60 HP (+15%) | +90 HP (+23%) |
| Torque gain | — | +120 Nm (+16%) | +165 Nm (+22%) |
Figures are examples/estimates and may vary with the car's mileage, maintenance condition, fuel quality and hardware. Exact results are determined by dyno/datalog.
Custom software · 11 options
Custom software options for this engine
Legend Tuned functions suitable for this engine, which can be applied in the same session as Stage software or on their own.
Emission Systems
Emission system solutions for track and motorsport projects.
- DPF/FAP Delete A motorsport-focused software solution for the faults, power loss and limp mode caused by a clogged diesel particulate filter (DPF/FAP).
- EGR Delete A software solution for the smoke, power loss and check-engine light caused by a carboned-up, failing EGR valve.
- AdBlue/SCR Delete A software solution to the no-start countdown triggered by faults in the AdBlue pump, injector, heater and NOx sensor.
- NOx Sensor Delete Software that addresses the check-engine light, power restriction and AdBlue warnings caused by faulty NOx sensors.
Legal notice: Software for emission systems (catalytic converter, DPF/FAP, OPF, EGR, AdBlue/SCR, etc.) is intended solely for track / motorsport and closed-course use. Driving vehicles with these systems disabled on public roads, and presenting them for TÜVTÜRK inspection, may be against regulations. On request, the original software can be restored.
Driving & Sound Effects
Make yourself heard and be first off the line.
Transmission (TCU) Software
Faster shifts, sharper response, proper torque management.
- Automatic Transmission Software (ZF / Aisin / 7G / 9G) Quicker, punchier shifting for torque-converter automatics such as ZF, Aisin, 7G-Tronic and 9G-Tronic.
- Torque Limiter Removal Software that rearranges factory torque restrictions based on gear, speed or transmission, within the limits of the drivetrain.
Fault & Function Solutions
Permanent software fixes for annoying faults.
- Fault Code Deactivation Software that permanently disables unnecessary fault codes in the ECU for systems that have been removed or are no longer used.
- Permanent Start-Stop Delete A solution that permanently disables the start-stop system that switches itself on at every start, or makes it remember your last setting.
- MAF/Air Flow Meter Delete Software that lets the ECU run on a calculated air model instead of a faulty or problematic MAF (mass air flow) sensor.
Stage 2 hardware, peace of mind and process
Stage 2 requirements
Stage 2 ready with the Custom Sport Filter Kit
At Stage 2, the engine's breathing is freed up with hardware, and the software is written to match that hardware. The target for this engine is 490 HP / 925 Nm.
- Air intakeThe made-to-measure Legend Custom Sport Filter Kit or an intake suited to the car.
- Intercooler & boostA vehicle-specific intercooler / blow-off valve to keep temperatures stable under sustained load.
- Silicone boost hosesHoses and pipes that withstand the higher pressure.
- Health checkIgnition, fuel system and clutch checked for this power level; the job takes ~4–8 hours (depending on parts fitted).
Included every time
Power with peace of mind
- Original software backup — the factory software is read and archived before the job.
- Reversal — the car can be returned to its original software whenever you ask.
- Datalog check — boost pressure, ignition and air/fuel ratio are recorded and checked on a road test.
- Vehicle-specific calibration — not an off-the-shelf file; tuned to the engine, hardware and fuel quality.
- Pre-tune diagnostics — fault memory is read and engine health is checked before the software.
-
Book
Tell us about your car and your goals; we'll plan the day and time together.
-
Analysis & backup
Fault memory is read, the ECU is identified and the original software is archived.
-
Legend Tuned software
Calibration tailored to the car (Stage 1: ~1–2 hours).
-
Test & handover
Verified with a road test + datalog, then handed over with a walkthrough of what was done.
BMW 5 Series (G30/G31)
Other engines in the same generation
- Petrol 520i 1.6 (B48) 170 → 220 HP +50
- Petrol 520i (B48) 184 → 250 HP +66
- Petrol 530i (B48) 252 → 287 HP +35
- Petrol 540i LCI (B58) 333 → 400 HP +67
- Petrol 540i (B58) 340 → 400 HP +60
- Petrol M550i xDrive (N63) 462 → 540 HP +78
- Petrol M550i xDrive LCI (N63) 530 → 650 HP +120
- Diesel 518d (B47) 150 → 190 HP +40
- Diesel 520d (B47) 190 → 220 HP +30
- Diesel 525d (B47) 231 → 270 HP +39
- Diesel 530d (B57) 265 → 310 HP +45
- Diesel 530d LCI (B57) 286 → 345 HP +59
- Diesel 540d xDrive (B57) 320 → 385 HP +65
- Diesel 540d xDrive LCI (B57) 340 → 410 HP +70
- Hybrid 530e (B48) 252 → 340 HP +88
- Hybrid 530e LCI (B48) 292 → 325 HP +33
- Hybrid 545e xDrive (B58) 394 → 440 HP +46
Other 5 Series generations
Vehicle Selector